IPsec is very secure and delivers great performance, and since 2018, Vigor Router also provides IPsec Xauth. If you are not comfortable with every VPN client using the same pre-shared key, you can use IPsec Xauth instead. IPsec Xauth authenticates the VPN clients not only by a pre-shared key but also a unique username and password. This article demonstrates how to set up Vigor Router as a VPN server for IPsec Xauth clients, and the configuration required on an Android device to establish the VPN.
1. Go to VPN and Remote Access >> IPsec General Setup, and enter Pre-Shared Key.
2. Go to VPN and Remote Access >> Remote Dial-in User, and click on an available index:
3. You may check if the client is online from VPN and Remote Access >> Connection Management page.
1. Go to User Management >> User Profile and click Add,
2. Go to VPN and Remote Access >> IPsec General Setup, Enter IPsec User Preshared Key. Then click Apply.
3. Go to VPN and Remote Access >> VPN Profile and add a profile as follows:
4. Go to Proposal tab to choose the proposal preferences. For Android 6 or 7, we recommend the settings below.
5. You may check if the client is online from Remote Access >> Connection Management page.
1 Go to Settings >> More >> VPN to add a VPN profile as follows:
2. To start the VPN connection, tap the profile, enter username and password. Then, tap Connect.
3. It shows the following information if VPN connects successfully.
Published On: Jul 04, 2018
Was this helpful?